HUECK Lambda WS 075 IS - Aluminium window with integrated sash
Highly thermally insulated aluminium window design with an integrated sash. Profile depth of 75 mm (frame). Sash lap on the room side 10 mm. Sash lap over the frame circumferential 6 mm.
Elevation width outside:
Fixed frame: from 68 mm
Interlocking frame: from 50 mm
Transom profile: from 93 mm
Sash profile: integrated
Elevation width inside:
Sash profile: 58 mm
Secondary sash profile: 36 mm
"Lambdatherm" insulating zone, heat resistant up to 180°C.
Factory-made shear-proof composite, suitable for subsequent powder-coating and anodization.
Highly thermally insulated centre seal gasket with limit stop on a hollow chamber profile insulating bridge on the sash side. Optionally with vulcanized corner gaskets or as a vulcanized frame gasket.
Circumferential EPDM rebate sash gasket.
Chamber-forming EPDM glazing gaskets, to be drawn in circumferentially.
Sash glazing on the outside with a vulcanized EPDM frame gasket.
All gaskets coated with sliding polymer, suitable for self-cleaning glazing.
Rebate chamber drainage through slot areas and clip-in drain caps (plastic or aluminium) or concealed drainage.
Filling thicknesses up to 42 mm in the fixed area and up to 50 mm in the sash.
Opening types: turn, turn/tilt, tilt, tilt before turn and French window
Sash sizes pursuant to catalogue.
High-quality, concealed fitting solutions.
Corrosion prevention class 5.
Combination with HUECK Lambda WS 075 possible.
Thermal insulation: Uf dependent of profile geometry ≥ 0.89 W/m²K
Water tightness: up to Class 9A in accordance with EN 12208
Air permeability: up to class 4 in accordance with EN 12207
Resistance to wind load: up to class C5/B5 in accordance with EN 12210
Mechanical stress: class 4 in accordance with EN 13115
Burglar resistance: up to class RC2 in accordance with EN 1627
Design-related deviating performance properties on request.